Approximately 1 year after purchase started developing a crack on the panel beneath the rear window.
02 explorer no door lock.
Press the power door unlock control three times.
Re upload from my old channel.
My 02 ford explorer power door locks just up and quit all at the same time.
Press the unlock control then press the lock control.
Two beeps one short and one long signals that the auto locks have been enabled so if you receive two beeps start the process over again.
Turn the ignition to off.
I have a 2002 ford explorer xls that was purchased new.
On the 2011 2018 ford explorer the passenger fuse panel is located under the instrument panel to the left of the steering column.
Push the power door unlock button once to turn on the auto lock feature.
One beep confirms the auto locks have been disabled.
They wont work with the fob or the combination pad outside the door either i need to know where the door lock relays are located and would love to have a door lock wiring diagram i already removed the drivers door panel and the rubber wire duct in the door jamb and found a red wire broken and tada.
Ford explorer since 1995 has been using an in door switch for the door jamb.
Average failure mileage is 95 400 miles.
The 2002 ford explorer has 7 problems reported for power door lock not working.
The horn will chirp.
The horn will chirp once if auto lock was deactivated or twice one short and one long chirp if auto lock was activated.
Turn the ignition back to on.
No door is opened but the doors refuse to lock and the warning light stays on.
The common problem is that the switch is not closed this will cause your dome lite to be on door ajar light on and will malfunction any aftermarket auto alarm.
Press the power door lock button once and listen for the horn to beep one time.
Older versions used a plunger that you could easily test with with your fingers.